Driven Steel Piling

Driven steel piling

A range of steel sections can be used for piles. The most common are tubes, universal columns (or H piles) and rectangular hollow sections. Driving piles, as opposed to drilling bores, can be advantageous because the soil displaced by driving the piles compresses the surrounding soil, resulting in greater friction against the sides of the piles, thus increasing their load-bearing capacity. In addition, as driving a pile displaces the soil rather than removes it, there is no cost of spoil disposal incurred. This can be particularly beneficial if the soil is contaminated.

A wide range of sizes of steel tube (or pipe) is commonly available and Piling Contractors have experience in driving tubes from 350 mm to 1500 mm diameter with wall thicknesses from 7 mm to 25 mm.

Tubular piles can be driven with either an open bottom end or closed end. When driven open end, soil is allowed to enter the bottom of the tube. If an empty pipe is required, an auger can be used to remove the soil inside following driving. If the soil is suitable internal cleaning could also be carried out by water jetting.

Closed end pipe piles have the bottom of the pile sealed with a steel plate or cast steel shoe. When driving through hard strata pile toes may be reinforced with a secondary driving shoe to assist penetration and minimise pile damage.

The structural capacity of tubular piles is primarily calculated based on steel strength and concrete strength (if filled). Corrosion can be dealt with by application of protective coatings, by allowing a sacrificial thickness of steel or by adopting a higher grade of steel than otherwise needed.

Steel tube piles can either be new steel manufactured specifically for the piling industry or reclaimed steel tubular casing previously used for other purposes such as oil and gas exploration. Most steel tube piles can readily be spliced to provide greater depth capability than a driving rig can accommodate.

H-Piles and Universal Columns (UC’s) are structural beams that are driven in the ground for deep foundation application. They can be easily cut off or joined by cutting and welding. If a steel pile is driven into a low pH soils or where water flows readily then there is a risk of corrosion, coal-tar epoxy or cathodic protection can be applied to slow or eliminate the corrosion process.

Sometimes a combination of steel tubes and steel piles are used to make a “combi wall” this benefits from the strength properties of tubular piles but at reduced materials cost.

Piling Contractors installs driven steel piles up to 1500mm diameter, up to 50m in single lengths and at rakes of up to 1 in 3. 

The processes consist of pitching and driving in a fixed land based leader or free driving piles with rope suspended hammers. Use of fixed leaders allows greater control of position and verticality.

When working over water the same installation processes are used or piles can be driven through our rotating marine leader which can traverse in all directions on and grid arrangement and rotate 360 degrees to pick up any pile on rakes up to 1 in 3 within a defined grid arrangement.